Quote:
Originally Posted by DJ's left nut
This is unbelievably good advice.
You'll never realize how difficult you were making things for yourself until you start doing proper milling with a jointer/planer. Its simple; run a board over a jointer until you get a nice flat 'wide' side (some people say run it with the smile up, others say smile down. Personally I tend to go with the 'frown' shape because it avoids rocking, you just need to be smart and not put too much pressure on it to end up working a curve into it.
Then you put your newly flat side against the fence and run it through to joint an edge. Then with a flat edge and flat surface, run it through a planer to get the wide surface. Finally you run it through the table saw to true up the other edge.
To have every one of your boards the exact same thickness and perfectly square with true corners makes everything you make a million times easier. Your corners come together right, you have to do far less sanding. It's just amazing.
First time I did it I realized I'd never go back to trusting a lumber-yard again. It's a miracle worker.
|
All great advice.
I was fortunate enough to inherit the 6" cast iron jointer my Dad bought new back in 63 and bought a new DeWalt 12 1/2 inch planer.
Had to flip the blades on the planer last week, wow what a difference. New set ordered to have on hand.