Thanks for the tips.
It looks like I'll disassemble all the metal, use a steamer on it and then dump it in a bucket of hot soapy water. I'll than scrub all the hard to reach areas with a toothbrush. Repeat that a couple times and than oil the parts.
For the wood, I'll either steam it, wipe off, repeat or bake it in the oven.
Wish me luck...afraid I'm going to either break a metal piece or ruin the wood.
EDIT: I'm alittle concerned with the removal from the wood. Wouldn't steaming it hurt the wood?
Last edited by Dunit35; 05-10-2011 at 12:24 AM..
|