I put in a new garbage disposal today. Didn't go too bad (minor cuts on my hand from the edge of the drain). All finished and I go flip the breaker, run inside and flip the switch. Nothing. I'm postive that I had good connections on the wiring, and I fiddle with the reset cutout on the bottom of the disposal, flip the breaker back and forth again, and still nothing. I almost decided to put it off until later. Then thought better of it and went to turn off the breaker again so i could check the wiring.
Oh. When I went to turn the breaker back on, I turned off a second circuit instead of turning the one that was off back on. Flipped both breakers on and I was good to go.
|