Quote:
Originally Posted by lawrenceRaider
Been thinking about trying one of the 80%'ers, how'd the process go for you?
|
There's 'easy' ways and there are harder ways. What I was originally planning to do was by the drilling jigs and do it manually. But then I got access to an industrial CNC machine and some jigs/program for it. That was the easy way, load the 80% in the jigs, load the program and press start. Wait until holes drilled. Flip the 80% in new jig for the pocket, load new program and press start again. A few minutes later a fully drilled out receiver. Then I had to deburr the holes and it's ready for engraving/anodizing. Most people do the manual rigs, I just happened to get lucky with the CNC machine.
__________________
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t*rd by the clean end"
|